Post by cw79 on Nov 18, 2016 11:29:40 GMT -5
Hi there,
First post - this thread has been a really good source of knowledge over the years when I've had problems with my PowerMax 155. Usually we had occasional problems with the pressure dropping and the system locking out. We've learnt to re-pressurise and fire the system up and all has been largely fine.
Just recently we are having problems with very little hot water although the central heating works just fine. I notice that when the boiler is set to advance or hot water constant the pressure is rising to over the one bar recommended pressure - almost at two.
The main problem is that with the timers in place for hot water, we are simply not getting much if any. The clock is set properly. In the past an early and late cycle.
Can anyone help?!
Thanks,
Chris
First post - this thread has been a really good source of knowledge over the years when I've had problems with my PowerMax 155. Usually we had occasional problems with the pressure dropping and the system locking out. We've learnt to re-pressurise and fire the system up and all has been largely fine.
Just recently we are having problems with very little hot water although the central heating works just fine. I notice that when the boiler is set to advance or hot water constant the pressure is rising to over the one bar recommended pressure - almost at two.
The main problem is that with the timers in place for hot water, we are simply not getting much if any. The clock is set properly. In the past an early and late cycle.
Can anyone help?!
Thanks,
Chris